how do i wire these components

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=114322
Printed Date: May 15, 2025 at 2:08 AM

Topic: how do i wire these components

Posted By: chevy sounds
Subject: how do i wire these components
Date Posted: June 08, 2009 at 11:22 PM

I got a new set of components and on the crossover they have an input for the mids and an input for the tweaters my stereo doesnt have enough channels and I dont know if an amp would blow the tweaters... So how should I wire these up? Would it be okay to link the + input on the mid to the + on the tweater and negative on - on mid to - on tweater input???

Thanks

Replies:

Posted By: haemphyst
Date Posted: June 08, 2009 at 11:25 PM

Yes. In fact, the crossovers SHOULD have come with a jumper, to do just that.

They are a bi-wirable component set, and if you were to wire an amp channel to each input, you would still be golden. Just make certaiun that the amplifier power does not exceed the power specified by the manufacturer, and you'll be fine.

-------------
It all reminds me of something that Molière once said to Guy de Maupassant at a café in Vienna: "That's nice. You should write it down."

Posted By: chevy sounds
Date Posted: June 09, 2009 at 12:09 AM

haemphyst wrote:

Yes. In fact, the crossovers SHOULD have come with a jumper, to do just that.

They are a bi-wirable component set, and if you were to wire an amp channel to each input, you would still be golden. Just make certaiun that the amplifier power does not exceed the power specified by the manufacturer, and you'll be fine.

All right thanks for the help

Print Page | Close Window