how to a eqs746?

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=115487
Printed Date: July 07, 2025 at 5:57 AM

Topic: how to a eqs746?

Posted By: imupabove
Subject: how to a eqs746?
Date Posted: August 05, 2009 at 7:49 PM

here is what i have install in my 93 camry:

ida-x200
mrp-m500
12" alpine type r
rf punch 240x4
6022i's
sps-69c3's
rfc1d

can someone please tell me how to install this EQ and if i need any additional items. thanks.

Replies:

Posted By: DYohn
Date Posted: August 05, 2009 at 10:09 PM

Follow the instructions in the owner's manual would be a good place to start. In case you don't have one.

-------------
Support the12volt.com

Posted By: ianarian
Date Posted: August 06, 2009 at 12:31 AM

Nice choice....its pretty clean. If you have a media player, especially "anti ipod" then there's a separate input with level controls for that. Thats the reason I got it. Other than that, it takes 1 input and now Fader, Vol and sub all control from there. FUSE the 12V+, I cant remember the fuse rating though, I wanna say 2A. Maybe an idiot can figure it out. 100db s/n --JHEA!! 7V pre-out works well with the MRP. 0.005% THD dude your stoked! Here's how I put mine in.
posted_image

I cut plexi-glass to fit over the hole. It was a small compartment before. Then just veneered it with carpet. I used 2 layers of carpet to make it appear recessed, or somewhat flush. I'm constantly boosting 16k and cutting 315k when playing Mp3's.

-------------
This is what I do for FUN!

Posted By: imupabove
Date Posted: August 09, 2009 at 2:35 AM

"FUSE the 12V+, I cant remember the fuse rating though, I wanna say 2A"

what do you mean by this?

regarding the "main in" on the EQ; where does the other end of the RCA go to? to the deck right? but which preamp out? front, rear, or sub?