me pair my amp to subs.
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=116599
Printed Date: May 11, 2025 at 9:22 PM
Topic: me pair my amp to subs.
Posted By: dellhater
Subject: me pair my amp to subs.
Date Posted: September 29, 2009 at 12:31 AM
I need two ten inch subs. They will be wired parallel in my box.
These are the specs to my amp I currently have.
Bass Boost Gain 0 to +18dB
Bass Boost Frequency 40 Hz
High Pass Frequencies 150 - 1500 Hz
Crossover Channel Qty 2 channel(s)
Additional Features Gold plated connectors, thermal protection, short circuit protection, DC protection
Amplifier Output Details 85 Watt - 4 Ohm - 2 channel(s) ¦ 105 Watt - 2 Ohm - 2 channel(s) ¦ 210 Watt - 4 Ohm - 1 channel(s)
Distortion Factor 0.02%
Output Power / Total 400 Watt
Low Pass Frequencies 40 - 120 Hz
High Level Inputs Yes
Continuous Power / Channel Qty 85 Watts x 2
Signal-To-Noise Ratio 97 dB
Response Bandwidth 10 - 30000 Hz
Amplifier Output 2-channel
Input Channel Qty 2 channel(s)
Crossover 2-way active crossover
Output Channel Qty 2 channel(s)
TIA!
Replies:
Posted By: dellhater
Date Posted: September 29, 2009 at 12:31 AM
1999
Honda
Civic
EX
Posted By: i am an idiot
Date Posted: September 30, 2009 at 8:34 PM
I don't really know if there is a question in there, but if you are dead set on paralleling the woofers, you will need either 8 ohm drivers or dual 4 ohm voice coils. The dual 4s must have the voice coils wired in series on each of the drivers, to yield 8 ohms per woofer which when paralleled will give you a 4 ohm load.
|