cadillac escalade 2004
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=119217
Printed Date: May 09, 2025 at 7:07 PM
Topic: cadillac escalade 2004
Posted By: oteroi1
Subject: cadillac escalade 2004
Date Posted: January 09, 2010 at 10:34 PM
How do you instal a hi and low adapter to a factory navigstgion radio on a 2004 cadillac escalade. I tried getting it from one speaker but the radios volume keeps going up and down
Replies:
Posted By: yimke
Date Posted: January 09, 2010 at 10:41 PM
Where did you grab the wires for it? If at the deck, then you HAVE to go after the amp.
Posted By: oteroi1
Date Posted: January 14, 2010 at 11:17 PM
i grad the wire that goes directly to the left speaker in drivers side. the color is BROWN / yellow
Posted By: CGARNES
Date Posted: January 17, 2010 at 10:28 PM
I grab them under the cupholders in the center console. If I remember right the colors are red and black. They are by themselves on a clip leading to the factory sub.
Posted By: yimke
Date Posted: January 18, 2010 at 9:20 AM
You probably grabbed the wrong wire. Did you test for resistance between the two wires? It should be around 8 ohms for the Bose setup. Also WHERE did you grab it from? In the door boot or at the speaker? Like I said if you are doing this behind the navigation unit, this will not work.
Go to the amp under the center console and grab your BROWN / yellow there, or tan/gray.
Posted By: zerepdivad
Date Posted: January 18, 2010 at 9:33 PM
Get he wires in the kick panel harness to the rear. Either side.
-------------
A DMM is a beautiful thing.
MECP Advanced Installer Certified.
|