newbie, hooking up amp

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=121428
Printed Date: May 14, 2025 at 1:35 AM

Topic: newbie, hooking up amp

Posted By: kevinjensen68
Subject: newbie, hooking up amp
Date Posted: April 19, 2010 at 10:13 PM

Need some help on hooking up my amp. Not sure if it will work but I have a 4 channel 500w sony amp, and i want it to run a 6x9 and a 10" sub. I have hooked mono amps to subs which is simple but as far as this goes I wanted to hook everything thing up right and just just start plug/playing until I burn something up.

The amp I am using is the exact same one as THIS, just was looking for help for speaker to amp hookup I have the simple ground/power/remote stuff down, thanks guys.

Replies:

Posted By: icearrow6
Date Posted: April 20, 2010 at 12:47 AM

which 10" sub do u have?

if its a 4 ohm sub then simply bridge channels 3 and 4 on the amp to the sub. use channels 1 and 2 to your 6x9

-------------

Posted By: kevinjensen68
Date Posted: April 20, 2010 at 8:20 AM

Its an old MTX blue thunder, I just googled it and all the subs just like it I found are 4 ohm so I am guessing mine is as well...

Print Page | Close Window