mojo mc1.2500?

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=122050
Printed Date: May 03, 2024 at 1:19 AM

Topic: mojo mc1.2500?

Posted By: sik4all
Subject: mojo mc1.2500?
Date Posted: May 29, 2010 at 10:42 PM

ok well i just got a brand new memphis amp (16-mc1.2500) . my ? concerns the fuse. it doesnt have an onboard fuse it comes with a seperate anl fuse holder. well i usually have a fuse holder comin off the battery should i have both fuse holders installed or just the anl fuse holder that came with the amp! another ? will be how is the easiest way too hook up a 2nd battery? thanks for any help and for takin your time to read this post any help will b really appreciated?

-------------
CLOWNIN

Replies:

Posted By: j.reed
Date Posted: May 30, 2010 at 3:43 PM

One fuse no more than 12 inches from battery. This protects the wire and should be fused for the wire.

The 2nd fuse, "amp fuse". Is to protect the amp and should be installed close to the amp.

To install a 2nd batt. Run a power wire from the first batt pos, 4 guage or larger dependent on amount of draw to the 2nd batt( i would use 0 gauge for this application. That amp pulls more than 4 gauge can handle.). Ground to GOOD chassis spot within 3 feet of the 2nd batt suffecient wire for return or you can also run from the - to the 2nd batt -. This battery should also have a fuse to protect the chargeing wire within 12 inches of the 2nd batt.

-------------
posted_image

Posted By: sik4all
Date Posted: May 30, 2010 at 5:04 PM

Alright thanks bruh could not have been explained any better! appreciate the info.

-------------
CLOWNIN