1999 dodge intrepid dash

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=122184
Printed Date: May 02, 2024 at 8:52 PM

Topic: 1999 dodge intrepid dash

Posted By: nightowl2
Subject: 1999 dodge intrepid dash
Date Posted: June 06, 2010 at 5:09 PM

I have looked everywhere for the steps to take the dash off so I can install the audio system but I can't find where to start. I can get the bezel to start to come off but it is very stiff and I'm afraid I'm going to break it. Do I need to take the glove box off and work my way over?

Replies:

Posted By: dasbogie
Date Posted: June 06, 2010 at 8:22 PM

it should pry off. use a panel popper tool. you can get a whole set at harbour freight for about 7 or 8 bucks

-------------
Advanced

Posted By: topinstaller200
Date Posted: June 08, 2010 at 1:43 AM

Begin by applying the parking brake. Turn the ignition switch

to the accessory position and shift the transmission into the neutral

position. Insert the hook tool behind the left rear corner of the bezel

that surrounds the shifter. This bezel also has the ashtray integrated into

it. Pull upward to release one (1) clip. Insert the hook tool behind the

right lower corner of the bezel and pull upward to release one (1) more

clip. Grasp bezel and pull upward and towards rear of the vehicle simultaneously

to release two (2) more clips located on the left and right sides

of bezel. When the bezel is loose, let it rest just in front of the center

armrest. NOTE: There is no need to remove the shifter knob.