amp clipping, shutting off

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=122711
Printed Date: May 02, 2024 at 9:42 PM

Topic: amp clipping, shutting off

Posted By: shije
Subject: amp clipping, shutting off
Date Posted: July 16, 2010 at 4:44 PM

my setup consists of:
1 Power Acoustik BAMF2000/1D monoblock amplifier
1 Power Acoustik 2ohm DVC MOFO brigded to 1.3ohms
1 VR3 1Farad digital capacitor
All 4guage power/ground cables

ok so my situation is my amp clips/shuts off for split seconds when the volume is turned to about 75%...and also i hear clicking sounds from the amp while the subwoofer is not running... is this because my amp's gain is not set properly?

-------------
BLT

Replies:

Posted By: icearrow6
Date Posted: July 16, 2010 at 6:32 PM

how to set your gains

-------------

Posted By: DYohn
Date Posted: July 16, 2010 at 7:14 PM

shije] wrote:

br>1 Power Acoustik 2ohm DVC MOFO brigded to 1.3ohms

This is impossible. If it's a DVC 2-ohm speaker, it can be wired for 4-ohms or 1-ohm, but not for 1.3 ohms.

-------------
Support the12volt.com

Posted By: roadshop570
Date Posted: July 16, 2010 at 8:04 PM

Check your voltage from your amp ground, is it mounted and/or are you using spacers under the amp for air flow? Is it in a location where its getting air? Whats your wire size?

-------------
Chadillac

Posted By: SOUND PRESSURE
Date Posted: July 19, 2010 at 10:58 PM

its over loading turn down the gains. check the way you wired your subs the amp may not be able to push it. check your grounds and make sure they are not tied into the seat belt.

-------------
Sound Pressure

You know you have the right amount of pressure when your eyes start to water! Now you've got Juice!

Print Page | Close Window