kenwood ps400m amplifier

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=12383
Printed Date: May 18, 2025 at 12:03 AM

Topic: kenwood ps400m amplifier

Posted By: shaneo
Subject: kenwood ps400m amplifier
Date Posted: April 18, 2003 at 3:04 PM

I have a kenwood ps400m amplifier and when everything is hooked up the amp turns on and the light is green but after it clicks it goes red and into a safe mode all of the fuses are fine and im running out of patience please help with any info, links or anything that might help

thanks a lot

shaneo

Replies:

Posted By: Cletis
Date Posted: April 18, 2003 at 3:52 PM

how do you have the amp wired up, and what do you have it hooked up to.

Posted By: shaneo
Date Posted: April 18, 2003 at 4:14 PM

The amp is wired to the batterie with 4 ga. wire the amp is mono so it is only hooked to one sub i think the power and ground connections are good.

hope this helps a little

shane

Posted By: Cletis
Date Posted: April 18, 2003 at 4:16 PM

what kind of sub (single or dual voice coil), how many ohms are each coil, and if a dvc, how is it wired (series or parallel)

Posted By: Cletis
Date Posted: April 18, 2003 at 4:32 PM

I'm not too familiar with kenwood amps, but i just downloaded the manual and it says that red indicates normal operation. If the light is green it means you have a problem. It is supposed to start green and then turn red after a few seconds. Is the amp working correctly.

Print Page | Close Window