2010 dodge ram radio wiring
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=126183
Printed Date: April 27, 2024 at 11:33 PM
Topic: 2010 dodge ram radio wiring
Posted By: stang351w
Subject: 2010 dodge ram radio wiring
Date Posted: February 16, 2011 at 8:35 PM
hello, i've got a customer that wants to keep his factory deck but run a aftermarket sub. i'm looking for the wiring on the deck for the rear speakers (useing a LOC for the RCA's) he doesn't have the full NAV system or 6 disk changer but he does have 6 speakers and it did have a factory sub. thanks in advance
-------------
Tri County KustomZ
certified installer
Replies:
Posted By: i am an idiot
Date Posted: February 16, 2011 at 9:37 PM
If it has a factory sub, you will have to get signal from the factory sub. If it has a factory sub, chances are the door speaker outputs of the radio will be crossed over. The only speaker that plays bass is the factory sub.
Posted By: stang351w
Date Posted: February 17, 2011 at 5:04 AM
alright thanks. the only problem is when i checked the wires where the factory sub was I used my DMM to find the power and ground (incase the amp was built into the sub box...wasn't sure) but i had 6,3VDC on each of the 4 wires.
-------------
Tri County KustomZ
certified installer
Posted By: i am an idiot
Date Posted: February 17, 2011 at 5:55 AM
Each of those 4 wires were speaker wires. There is a Dual Voice Coil woofer inside that box. You will need to remove the woofer to see which wires are positive and negative.
Posted By: stang351w
Date Posted: February 17, 2011 at 8:23 PM
would like to say thanks for the info..got everything connected and working tonight...the LOC used provided a remote on so that made things go really nice.
-------------
Tri County KustomZ
certified installer
|