Print Page | Close Window

wire two 4ohm dvc subs to amp

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=126822
Printed Date: May 13, 2025 at 6:41 PM


Topic: wire two 4ohm dvc subs to amp

Posted By: tak4
Subject: wire two 4ohm dvc subs to amp
Date Posted: April 02, 2011 at 11:48 PM

So I have two 12" Kicker CVRs that are 4ohm DVC @ 800rms (total)
I also bought a Kenwood KAC-9105D 1800watt mono that does 900rms @ 2ohms. But I was told that i cant wire it to 2ohm, only 4ohm or 1ohm.
In the specs on the Amp it says "stable 1ohm - Yes" does that mean I can wire my subs to 1ohm load and wire to the amp just fine?

I cant seem to find an answer to this problem.



Replies:

Posted By: DYohn
Date Posted: April 03, 2011 at 9:19 PM
Yes that amp is rated as 1-ohm stable.  Make very sure you set your gain properly.

-------------
Support the12volt.com


Print Page | Close Window