wiring on sealed box
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=127511
Printed Date: May 13, 2025 at 11:27 AM
Topic: wiring on sealed box
Posted By: harobikes333
Subject: wiring on sealed box
Date Posted: May 31, 2011 at 9:18 PM
Replies:
Posted By: i am an idiot
Date Posted: May 31, 2011 at 9:51 PM
Both positive amp terminals are connected together inside the amp. Same with the 2 negative terminals. It does not matter which + or - terminal you use.
Posted By: harobikes333
Date Posted: May 31, 2011 at 10:03 PM
Alrighty but otherwise it looks good...? I'm attempting to get my ohm meter to read 1 ohm but it just says 0 ohms or .1 ohms if i'm lucky >_< ?
Posted By: i am an idiot
Date Posted: June 01, 2011 at 2:11 PM
Touch your meter leads together. What does that read? Is it an autoranging meter? If not, which setting do you have it on?
Posted By: harobikes333
Date Posted: June 01, 2011 at 7:20 PM
They read 0.0 pretty much / or .01 It's on auto range... it's a fluke meter Where should I be touching on the terminal to read 1ohm
Posted By: i am an idiot
Date Posted: June 01, 2011 at 9:40 PM
What model is the Fluke?
Posted By: harobikes333
Date Posted: June 05, 2011 at 4:42 PM
Nvm. I got it to show around .9-1ohm. I just had to get it on the AMP terminals and hold them there for quite a while and it slowly built up ^^
Still haven't set the gain yet so I haven't seen what this new amp can do.... :/
|
