x1200m amp
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=127787
Printed Date: July 05, 2025 at 4:52 PM
Topic: x1200m amp
Posted By: joemon
Subject: x1200m amp
Date Posted: July 01, 2011 at 11:59 PM
Ok I have 2 of the Kenwood excelon x1200m bass amp and I have 1 KCA-WR10 bass remote.
So now the question is how do I get the bass knob to work with both amps at the same time?
The manual says to set 1 as master and 1 as slave and patch the RCA cable from master amp to the slave amp....
But wen I did that only the master amp gained up while the other stayed the same volume...
But in the KCA-WR10 manual it says to use a phone spliter to use on both amps...
But the same happened wen I did this too...
So...... plz help I've been searching for soo long and CANNOT find a Damn thing!!!
Thanx for all the help guys in advanced
Replies:
Posted By: joemon
Date Posted: July 03, 2011 at 11:53 AM
Any1..???
No1 knows of this amp??
Posted By: dukesrebelyell
Date Posted: July 03, 2011 at 1:11 PM
theoretically if its set up as master/slave then anything you do to the master should be duplicated on the slave. however, have you tried to plug the bass knob directly into the slave without the splitter? if that doesnt work you probably have a bad amp or there is a switch in the wrong position.
-------------
35 Hertz custom car audio and automotive fabrication
Posted By: joemon
Date Posted: July 03, 2011 at 4:58 PM
Ya I can plug the bass remote right into the slave amp and it will gain and down just fine but wen I put it back to the master and gain it the slave don't gain with the master..
I'm sure I'm doing something small that's wrong if its suppose to be this simple...
Both amps r only a month old
|