need a pro to design slot port box
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=129066
Printed Date: May 03, 2024 at 8:13 AM
Topic: need a pro to design slot port box
Posted By: rallystang
Subject: need a pro to design slot port box
Date Posted: November 02, 2011 at 11:35 PM
I have a center console I'm building for a new Escalade. I am not good at box design and could use a hand. Will pay a "Reputable" volter for design prior to delivery, name your price. The box is about 2.0 SQFT if you take into account the sub displacement and the .2 cuft cupholders. Sub is down firing, with port exit down firing as well.
Music goals:
Strictly SQ. Mostly Hip Hop, but needs to sound good for whatever is played. Tuning HZ is your call. The TI loves to go "Deep". Overexcursion is a concern as well being down firing and due to the nature of this sub(has happened in previous slot box on certain notes).
Sub: Titanium Eclipse @ 2 Ohms
Amp: MTX Jackhammer 600 RMS
Material: 3/4 MDF and 3/4 Polycarb
INSIDE DIAMETER DIMENSIONS:
Height: 13.75
Width: 12.5
Depth: 24
Sub specs:
RE - 3.1 ohm (each VC)
FS - 27hz
qts - .30
vas - 3.2 ft^2
spl - 89db
qes - .32
qms - 5.0
sd - 490 cm^2
xmax - 38mm
woofer displacement - .19 ft^2
Front and possibly rear of box are going to be polycarb. I am happy with 3/4 MDF. Final box will have music controller with LED's, and be wrapped in Gator and Leather. Will send designer a youtube link once finished. The front of the box is slightly angled back(14:1 pitch), hence depth measurement was given as average depth.
-------------
Thump.
Replies:
Posted By: knotdrummer88
Date Posted: November 03, 2011 at 8:38 AM
go to pwkdesigns.com check him out he does awesome work
Posted By: rallystang
Date Posted: November 03, 2011 at 3:08 PM
I sent him a quote form. Thanks!
-------------
Thump.
|