adding 4 channel amp to 2010 camaro
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=130894
Printed Date: June 20, 2025 at 9:00 AM
Topic: adding 4 channel amp to 2010 camaro
Posted By: ecko04
Subject: adding 4 channel amp to 2010 camaro
Date Posted: March 12, 2012 at 10:12 PM
I'm trying to add a 4-channel amp to a newer model Camaro and I have some questions.
The basics:
This is not a factory amplified system so non-BA (Boston Acoustics)
4-channel will be added to the factory head unit
However, the door chime, OnStar, bluetooth, etc. come through the speakers and the customer would like to retain these.
So my question is, how can this be done. It's easy enough to grab the rear speaker inputs from the rear deck. However, my concern is the front speakers. I would have to use a 4-channel line out and i've looked up the Pac Audio AA-GM44, which is a T-harness. If I use that harness, I would only have RCA out. How would I go about grabbing the speaker level inputs to run to the amp?
That's basically my question, where/how would I go about grabbing the speaker level inputs?
-------------
Replies:
Posted By: b_real45
Date Posted: March 14, 2012 at 1:58 PM
If you're using the Pac Audio AA-GM44, then you use those RCA outs to your new amplifier and won't need to use speaker level inputs. Then speaker wire would be run from the amp to your new speakers.
-------------
Rob
|