ok it been awhile but im sure I know how to do this. Ok I have my Hifonics Brutus BRZ 1200.D hooked up to my 12"Fosgate p3 dvc 4ohm. sub is parellel to 2 ohm.
downloaded a 0db 60htz test tone. stero bas is at 0 on factory radio. turned amp gain all the way down put digital multimeter on subs with amp hooked up.
2. played test tone in repeat with radio at 3/4 volumn
3. I can turn the gain up to 42 volts before i hear any distortion.
If my calculations are right thats around 950 to 975 watts rms out of this amp
my p3 in a slot port enslosure at 1.8 cu, sub settels nicely at this level turned up to max excursion and turned down till sub setteled. hits so freeking hard.
I wonder how long this sub will last at 900 rms lol.
I might be looking into getting a new sub soon.
What do you think about this setting?
I dont think my neighbor likes it to much, even though he cam out to check it out and He want a system now. He said I was viberating his house lol.
Thanks for any comments
wheelerdr wrote:
What do you think about this setting?
As long as the amp's not clipping you shuld be good to go.
-------------
Support the12volt.com
no clippin at all very strong amp. but I had to turn it down. Its hitting to hard. I guess I'm getting old lol.
Tok the p3 d4 back to my buddy to get the p3d2 he did not have one but he gave me a T0d212 cant wait to get home now