Print Page | Close Window

making subwoofer rings

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=131704
Printed Date: May 18, 2024 at 2:48 AM


Topic: making subwoofer rings

Posted By: tegguy
Subject: making subwoofer rings
Date Posted: June 27, 2012 at 6:48 AM

I am in the process of making my sub-woofer mounting rings for my enclosure (fiberglass). I am getting ready to cut the flush mount ring (the outer ring) and had a couple questions.

1) What size roundover bit should I use to do this? I am using 1/2" MDF for the outer ring 3/4" for the inner ring(the ring the sub screws to)

2) I do not have a router table what would be the best way to round the edges?

Thanks in advance



Replies:

Posted By: tegguy
Date Posted: June 28, 2012 at 7:24 AM
Anybody? I tried to do this last night and my ring came out with a ridge on the top (I think I cut too deep)


Print Page | Close Window