Hey hope you guys can help. Im trying to find a part and i don't know what the name of it is exactly. I haven't seen it in years as a matter of fact so i don't know if its even available now. Basically the best way i can describe it would be kinda a cap bus bar. Basically was a brass or gold plated piece that you would put on top of your capacitor and you would put 1 wire on each end. And it had a screw in the middle that you would attatch to your capacitor. Would look something like this.
..... .....
. A .______B_______. C .
._____________________.
One side of your wire would go on a the other would go on C and where b is would be a hold where you would put your screw to attatch it to your capacitor. I'm looking for this cause it would make my battery install a lot cleaner than it is now. I use to use them all the time back in the day (back when i didn't know that caps were useless) but i haven't seen in for some time. Thanks.
You could make your own by drilling the appropriate size holes into a piece of copper bar stock...
-------------
Support the12volt.comDYohn] wrote:
You could make your own by drilling the appropriate size holes into a piece of copper bar stock...
https://store.electrical-insulators-and-copper-ground-bars.com/
Probably some place local would work... Just a reference...
This link is the same company. The first link is there online store...
https://www.stormcopper.com/products/Battery-Connectors.htm
-------------
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!