mini to std din, balanced lines
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=133703
Printed Date: May 28, 2024 at 7:25 PM
Topic: mini to std din, balanced lines
Posted By: fuster
Subject: mini to std din, balanced lines
Date Posted: February 26, 2013 at 10:39 AM
I need to make a couple balanced lines with a 6 pin mini DIN male connector on one end and a standard size 5 pin DIN male connector on the other end. Purpose is for use with a Soundstream Balanced Line Transmitter and hooking it to an Orion 4100gx which uses standard 5 pin DIN female chassis mount jacks for the inputs. It does not have any RCAs for input jacks.
Is there any reason I can't use the Soundstream BLT with the Orion amp?
If not, then what I need to know is what type of cable to use and how many conductors the cable must have. I was thinking the BLT only would use 4 of the 6 terminals on the mini DIN and so I could buy some type of 4 conductor cable, but I don't know what cable to use with this project, so if anyone can help point me in a direction to find a cable on an on line electronics supply store, I would be much appreciative. Any other thoughts on this are also welcomed.
Thanks,
Mike
-------------
Chronic, late stage optimist.
Replies:
Posted By: fuster
Date Posted: February 27, 2013 at 1:03 PM
Hello? Someone out there must have some answers to this question!
-------------
Chronic, late stage optimist.
Posted By: Ween
Date Posted: February 27, 2013 at 8:36 PM
two pair of shielded twisted pair
|