07 mustang speakers pop
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=133873
Printed Date: May 10, 2025 at 5:22 AM
Topic: 07 mustang speakers pop
Posted By: window
Subject: 07 mustang speakers pop
Date Posted: March 16, 2013 at 10:38 AM
does anyone know the name of the part that will eliminate the speaker pop when i turn on the radio i know radio shack sells it just dont remember the name of it oh i replaced the factory radio
Replies:
Posted By: pentavolvo
Date Posted: March 16, 2013 at 1:29 PM
You need a 5 volt regulator on the turn on line
Posted By: window
Date Posted: March 16, 2013 at 2:44 PM
Posted By: i am an idiot
Date Posted: March 17, 2013 at 4:06 AM
Take 2 470 ohm 1/2 watt resistors. Wire them in series. Connect the remote wire from your aftermarket radio to one end of the device. Ground the other end of the device. Connect the factory amp turn on wire to the junction between the 2 resistors. Insulate the device and enjoy pop free audio.
Posted By: Ravendarat
Date Posted: April 29, 2013 at 12:47 PM
Uh a simple solution is just put a 1k resistor on the remote turn on wire off the deck then hook the other side up to the remote turn on in the vehicle. No more pop
-------------
double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer
Posted By: tonanzith
Date Posted: May 02, 2013 at 10:40 PM
1k resistor usually does the trick. Some times I've had to bump it up to 1.5 but eitherbway that always does the trick.
-------------
Gary Sather
|