dvc sub 4 channel amp

Is it somewhat alright to connect a 4 channel amp to a 4 ohm dvc sub by splitting the LEFT rca into 2 (Y adapter) and connecting it to channels 1 and 2 on amp 1 and splitting the RIGHT rca into 2 (Y adapter) and connecting it channels 1 and 2 on amp 2 (another 4 channel amp). Set gains using VOM ( no scope available), each coil on each sub would get the exact same signal (mono) Im waiting for 2 mono amps, so in the meantime, i want use what i already have. Both amps (4 channels each) are rated at 150w x 2 @ 4 ohms in bridged mode. This way each sub will get 300 watts.
I know not typical hook up, but, any advice would be appreciated.
Ron
2001 Hyundai Accent
Canada
2 Dual xpa 6100
1 Clarion apx 200.2
Pioneer deh 6300ub

Sure, you can do that.

-------------
Support the12volt.com

Thanks for the quick response, I appreciate it.

I have a set of Pyle subwoofers, 15" dvc 4 Ohm, I can't seem to find the TS parameters.... Anywhere, not even from Pyle, PLPW15D if it helps. Need to know this info for enclosure size. Please help!!!!!

I didn't want to be the one to actually SAY it...

You'll have to spec them out yourself, sadly.

-------------
It all reminds me of something that Molière once said to Guy de Maupassant at a café in Vienna: "That's nice. You should write it down."

Sad but true, emailing Pyle was pointless, calling was a joke, so I took the model closest to it and half ass'd it. Pretty sad when a company doesn't know it's own product!!!!lol!!!!!!