2013 dodge caravan stock radio wiring diagram

Hey i have looked everywhere, does some one happen to have a wiring diagram for this? Thanks

What are you trying to do?

I have a stock radio/dvd player with stock harness, out of a 2013 dodge grand caravan, trying to install into anouther vehicle, how ever the wire colors are different and cant not find out what wires go where

I am pretty sure that is a data controlled deck. There is not a 12 volt wire to tell it to turn on.   What kind of vehicle are you trying to put it in?

An older 98 chevy blazer

Im not to familiar with data controlled decks, im taking it is hard, or impossible to hook up in anouther vehicle.

I am not going to say impossible, but I will say improbable.

Base radio

-------------
Gary Sather

The only way this MAY be able to happen is if you can get the vehicles computer and associated harnesses, and Gary above can provide you with the same type diagram for said computer. I am pretty sure all you will need from the puter are constant power, ground, and the Ignition sense wires to power it up. Then provide the 2 can bus wires from puter to radio. And probably drivers door trigger wire. Door trigger wire is needed to tell the radio to turn off when you get out of the vehicle. I have never tried this before but I am pretty sure that is all you will need from the computer. If you can access that with all of the plugs associated, And Gary can provide the diagram for the BCM or whatever Chrysler calls their Body Control Module, it may happen.

I just noticed Gary's diagram says base radio. Make sure your radio harness has the same wire colors. It should, but make sure before we attempt to move forward. Especially the 2 can bus wires. Not necessarily the ones that go to the steering wheel controls, but the 2 labeled Computer Data Lines System.

I also have diagrams for the other radios as well if needed.

-------------
Gary Sather