Kicker cvr 12’s 2ohm dvc wiring advice

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=141533
Printed Date: May 14, 2025 at 2:17 PM

Topic: Kicker cvr 12’s 2ohm dvc wiring advice

Posted By: joeanybody
Subject: Kicker cvr 12’s 2ohm dvc wiring advice
Date Posted: July 23, 2016 at 1:15 PM

I have an tryin to wire two 2ohm dvc kicker cvr 12s to 2 ohms on a 2 ohm stable mono amp. I have viewed numerous wiring diagrams feel pretty good about some jus needing little more reassurance. Thanks in advance

Replies:

Posted By: joeanybody
Date Posted: July 23, 2016 at 1:16 PM

Wiring subs to a planet audio 1500.1 mono amp 2ohm stable

Posted By: lurch228
Date Posted: July 23, 2016 at 1:29 PM

For lowest wire Resistance for the size you will use, Wire each DVC sub in series and parrel them to the Amp.

Posted By: i am an idiot
Date Posted: July 23, 2016 at 6:54 PM

If you need a picture.

https://www.the12volt.com/caraudio/woofer_configurations.asp

Posted By: lurch228
Date Posted: July 24, 2016 at 2:44 PM

To keep wiring resistance the same for both subs run the parallel wires all the way to Amp so you have 2 positive and 2 negative at Amp terminals. Matching all wire lengths between subs. If you run 1 wire to Amp you will need to run a lot heavier gauge speaker wire to keep the Resistance as close to 2 Ohms. Smaller gauge wire at higher wattage's will drive ohms up lowering overall output.

Print Page | Close Window