Print Page | Close Window

2016 Mazda CX3 Sport, New System, No Sound

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=145173
Printed Date: May 13, 2025 at 12:29 PM


Topic: 2016 Mazda CX3 Sport, New System, No Sound

Posted By: scottwrrn
Subject: 2016 Mazda CX3 Sport, New System, No Sound
Date Posted: January 21, 2019 at 4:52 AM

2016 Mazda cx-3 sport I am putting in 2 sets of components, audio control lc7i a 4 channel amp and a sub and amp, I’ve located wiring harness under passenger kick plate and have found the wires, i ran a 9 in 1 to front hooked into speakers and back to dsp, but when I turn everything on I am not getting the sound or power from amp??
The amp is powered and rca to dsp. I get no sound from sub at all. I’ve read the user manual to dsp and don’t understand what’s going on. Everything has power and is on. Also do I need to use the cross overs that came with speakers if I am using the dsp? Thanks in a adVance for any help

-------------
Scotty



Replies:

Posted By: i am an idiot
Date Posted: January 21, 2019 at 6:23 AM
Do not play the speakers without the crossovers.




Posted By: scottwrrn
Date Posted: January 21, 2019 at 9:52 AM
Ok thank you 1 question answered

-------------
Scotty




Posted By: i am an idiot
Date Posted: January 21, 2019 at 12:32 PM
Did you use a volt meter to verify the amp and DSP are getting adequate power? The power indicator on an amplifier or a processor is not always confirmation of power and ground.

Did you connect a known good speaker to the wires at the input of the DSP to verify that it has signal?




Posted By: scottwrrn
Date Posted: January 27, 2019 at 12:54 PM
ok so little confused you asked did I install good speaker at input is dsp and verify sound? How do you do that. To my knowledge and please correct me if I am wrong but does the speakers come into dsp and then rca cables out to amp and speaker lines getting hooked into amp?

-------------
Scotty





Print Page | Close Window