Hitron HB-2 Bass Knob Replacement Cable
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=145329
Printed Date: May 14, 2025 at 7:39 PM
Topic: Hitron HB-2 Bass Knob Replacement Cable
Posted By: nuttinspecial
Subject: Hitron HB-2 Bass Knob Replacement Cable
Date Posted: March 31, 2019 at 7:03 AM
I picked up the HB-2 bass processor but did not get the 6 wire RJ-45 cable with it. Looking at the ends with the clip side down I have from left to right ; blue , yellow , green , red , black , white and then the oposite on the other end ; white , black , red , green , yellow and blue. I am not sure what pairs to solder after I cut the cable in half to make it work. Hope this makes sense. Thank you in advance.
-------------
BassHeadz4Life
Replies:
Posted By: i am an idiot
Date Posted: March 31, 2019 at 8:31 AM
If the cable you have came from a telephone system, you need to cut the cable and flip it. Solder 1 to 6. 2 to 5 and 3 to 4.
Posted By: nuttinspecial
Date Posted: March 31, 2019 at 11:56 PM
So blue to white. Yellow to black. Green to red. What about wire 4,5,and 6 from cable side (A)? I am designating the cable half that starts with blue yellow ... as cable (A)
-------------
BassHeadz4Life
Posted By: i am an idiot
Date Posted: April 01, 2019 at 6:07 PM
Did the cable you have come from a phone system? If so,
Blue to White. Yellow to Black. Red to Green.
Posted By: nuttinspecial
Date Posted: April 02, 2019 at 9:14 AM
I have no idea where the cable came from. All I know is that the 6 wires are flipped at one end meaning that it starts with white , black etc... exact opposite of the other end. Are you saying to only solder the 3 pairs of wires that you said? Do I leave the remaining 3 pairs disconnected? The bass processor has 2 knobs on the bass controller if that helps.
-------------
BassHeadz4Life
|