hey i'm new to installing remote starters i'm trying to find some info on ground out wire,starter interupt wire and the fifth relay or second ignition or weather these wires need to be connected i'm installing into a 1993 nissan maxima gxe thanks for your time
No second IGN wire or any need for the GROUND OUT wire either. The starter interrupt is an optional hook up but you will also need another relay for the: 2nd Starter Relay Circuit
| ITEM | WIRE COLOR |POL| WIRE LOCATION |
| 12V|WHITE/ red or white |+ |ign. harness *1 |
| STARTER|blk/yel or wht/blue |+ |ign. harness *1 |
| SECOND STARTER|grn/wht or grn/red |+ |ign. harness *1 |
| IGNITION|blk/wht or wht/grn |+ |ign. harness *1 |
| ACCESSORY|white or WHITE/ red |+ |ign. harness *1 |
| POWER LOCK|gray/RED / silver dots|- |door lock timer R of column |
| POWER UNLOCK|lt. blue/silver dots|- |door lock timer R of column |
| PARKING LIGHTS +|RED / yellow | |harness by st.column |
| HEADLIGHTS|RED / yel and RED / blu |+ |harness by st.column |
| DOOR TRIGGER|org/blk/ sil dots |- |anti-theft module *2 |
| TRUNK/HATCH PIN|pink/blk/ sil dots |- |anti-theft module |
| HOOD PIN|gray/blk/ sil dots |- |anti-theft module |
|TRNK/HTCH RELEASE|lt.grn/blk,brn |-,+|entry mod, dr. kick *3 |
| FCTRY ALARM ARM|lt.grn/wht/ sil dots|- |anti-theft module |
|FCTRY ALRM DISARM|lt.grn/blk/ sil dots|- |anti-theft module |
| TACHOMETER|lt. grn/blk or blu | |trans. ECU *4 |
| BRAKE WIRE|RED / white |+ |brake pedal switch |
| HORN TRIGGER|BROWN / white |- |steering column |
| WIPERS|blue/orange |- |steering column |
| LF WINDOW UP/DN|blue/red, blue/black|A |must go into each door |
| RF WINDOW UP/DN|blue/red, blue/black|A |run wires to motors |
| LR WINDOW UP/DN|blue/red, blue/black|A |avoid resistors inline |
| RR WINDOW UP/DN|blue/red, blue/black|A |rest at ground |
Notes:
*1 There appear to be two variations on ignition switch wiring colors. Test carefully to verify wire functions. *2 Anti-theft module located to left of steering column. Says Theft Warning on module. *3 Keyless entry module located by glove box in right kick panel. Release switch in door. *4 Trans. ECU behind center console above engine ECU. Wire facing dr. side of vehicle in blue plug. May also find GREEN/ black above dr kick on some models
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
thanks for the detailed info just have one question you stated no need for ground out wire and starter interupt but the fifth relay wire from the device has to be connected through a relay is that right sorry for the lame q thanks for your time
If you are using the 5th relay wire to engage a relay ( that would mean that this wire is a - trigger ), then use it for the 2nd IGN wire for remote start. I don't know what the characteristics of this 5th relay wire is but make sure that it will loose power to it after remote starte sequence has been taken over by the user.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
so at the ignition i've just soldered connections on to wires does the second ignition wire have to be connected the manuel states it can be used to trig a relay stating 30 amp output thanks velocity