Print Page | Close Window

JBL 300.1 and 2X JL w0

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=22151
Printed Date: May 15, 2025 at 11:50 AM


Topic: JBL 300.1 and 2X JL w0

Posted By: skiflyer45
Subject: JBL 300.1 and 2X JL w0
Date Posted: November 30, 2003 at 9:34 PM

I recently bought a jbl bp300.1 to hook up to my 2 12"JL w0's. Anyways....I hooked everything up, however it is just not loud enough. I run a Jensen 300 watt amp before and the jbl is not a single little bit louder, it might even be less.Is there a way to brigdge on this amp......has anybody a similar setup???? Any tips or suggestions??
Thanks in advance



Replies:

Posted By: Ketel22
Date Posted: November 30, 2003 at 10:15 PM
whats the current setup? and isnt the amp a mono block?

-------------
Quad L Handyman services



Posted By: skiflyer45
Date Posted: November 30, 2003 at 10:19 PM
i have two boxes....ca. 1.2cu each, level and bass boost at full, each sub to one output.
Headunit is a clarion.
I'm not sure if there is another way to wire it? Do you know?



Posted By: bfog99
Date Posted: November 30, 2003 at 10:33 PM

That is the only way for you to wire it. What if you play with the corss over points?




Posted By: wvsquirrel
Date Posted: November 30, 2003 at 10:46 PM
Deffinately DO NOT attempt a bridge with that amp. It has 2 sets of speaker outputs, but they are really the same channel and are already Internally Bridged.

Try raising the sub level output from the headunit if available.

-------------
Squirrel
"No more Cpt. Kirk chit chat"
If its too loud, then you're too old
Donate to the12volt.com



Posted By: skiflyer45
Date Posted: November 30, 2003 at 11:15 PM
what are the cross-over points???


Print Page | Close Window