Door Speaker Cable and LEDs
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=22695
Printed Date: May 13, 2025 at 8:37 AM
Topic: Door Speaker Cable and LEDs
Posted By: vmail
Subject: Door Speaker Cable and LEDs
Date Posted: December 11, 2003 at 7:55 AM
Hi, I would like to use my door speaker cable to create a blinking LED on the door for the alarm, the only problem is that the LEDs blow up when the radio is on. It is very difficult to feed new wires to the door because there is no space
Replies:
Posted By: xetmes
Date Posted: December 11, 2003 at 8:28 AM
hmmm that an odd idea... you could use a relay to disconeect from the radio when the car is off, and reconnect back to the radio when the car is on. i would not use both of the speaker wires though, just let one float and use the chassis for ground... i dont know about the whole idea though... hah
Posted By: vmail
Date Posted: December 11, 2003 at 8:55 AM
hmmm but if I enable the alarm while the radio is still playin, it will still blow up
Posted By: xetmes
Date Posted: December 11, 2003 at 10:21 AM
well have it disable when the key is in acc.... why would you have the radio on and the alarm armed?
Posted By: vmail
Date Posted: December 11, 2003 at 11:14 AM
by accident, some times when filling up with petrol, the system is still on, 2 mins later the immobiler kicks in and the LED starts flashing
Posted By: crudeau
Date Posted: December 11, 2003 at 11:43 AM
You can't get one 20-22 gauge wire to fit in there somehow?
Posted By: vmail
Date Posted: December 11, 2003 at 12:15 PM
only way it to cut the wire harness, but then the wires will be unprotected
|