installing preamp outputs on factory reciever
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=2424
Printed Date: August 05, 2025 at 1:56 PM
Topic: installing preamp outputs on factory reciever
Posted By: rswltz
Subject: installing preamp outputs on factory reciever
Date Posted: August 01, 2002 at 9:30 PM
I am installing new speakers and amplifiers in my new toyota camry. I want to keep the factory reciever but don't want to degrade the sound quality with a line output converter. I understand that it is possible to open up the reciever and tap into its preamp board. Does anyone know how to do this, or where I can find information on doing this?
-------------
rswltz
Replies:
Posted By: GlassWolf
Date Posted: August 01, 2002 at 9:58 PM
I could do that most likely but it isn't an easy task if you don't know your way around PC Boards.
I'd recommend this. get a line-level converter, and go straight into an Audio Control Line-Driver. This will allow you to take that signal and turn it into a solid 9V line level signal through the Audio Control's pre-amp. you'll have great results.
Much better than anything you'd even get with straight line-outs on the factory stereo since I don't think it'll be supplying a 9V or 12V signal for ya. probably not even a 4V
-------------
-GlassWolf
Pioneer Stage-4, Orion, DynAudio, Fi
|