Print Page | Close Window

wiring amp to two 4 ohm DVC woofers

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=29603
Printed Date: August 26, 2025 at 10:50 PM


Topic: wiring amp to two 4 ohm DVC woofers

Posted By: moose02623
Subject: wiring amp to two 4 ohm DVC woofers
Date Posted: April 03, 2004 at 11:14 AM

I have a noob question for you guys..
okay here it goes. I have an old puch 100.2 (light grey) and I just purchased 2 kicker compvr dual voice coil 4ohm 12's the amp is bridged. I am confused on how to hook this up

my last set of speakers were 2 jl w3d4's on the same amp as above and the way that was wired is the (+) of one voice coil was connected to the (-) voicecoil on the other side of the speaker. The (+) and (-) from the amp was connected to the remaining pos and neg coils

Any help on this would be greatly appericiated
Thanks In Advance



Replies:

Posted By: DYohn
Date Posted: April 03, 2004 at 11:50 AM

Your amp requires a 4-ohm load (minimum) when bridged.  It should be connected like this:

posted_image




Posted By: moose02623
Date Posted: April 03, 2004 at 7:01 PM

Thanks a Ton for the quick reply... Got them hooked up and sounding great!

Thanks Again





Print Page | Close Window