How do I Break In my system
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=30837
Printed Date: May 09, 2025 at 11:22 PM
Topic: How do I Break In my system
Posted By: aaron189
Subject: How do I Break In my system
Date Posted: April 22, 2004 at 12:27 AM
I just completely redone my system and i was wondering what is the right way to safely break it in. I have 2kenwood kfc6959ie 200 watt 6x9's and two kfc1679ie 160 watt 6 1/2's. I also have two Kenwood kfcw3005 12" 4-ohm 1400watt subs with a kenwood 800 watt amp. its not much but its a start. the stuff is all brand new and i was wondering what a safe way to break this all in is. Thanks in advanced. Aaron
-------------
~*~ Scribbster~*~
Replies:
Posted By: xTimx
Date Posted: April 22, 2004 at 2:05 AM
well like i said in the topic in breaking in subs. you can play it loud, but just remember to have no distortion what so ever. distortion is a bad friend that you dont want to have around! lol
-------------
xTimx
Posted By: kickerstang
Date Posted: April 22, 2004 at 6:43 AM
SET YOUR GAIN TO MATCH THE OUTPUT OF YOUR HEAD UNIT. PLAY IT NORMAL TO HARD FOR ABOUT A WEEK AND THEN YOU CAN START TWEAKING A BIT MORE
-------------
what!?!?! you want some??
Posted By: defective
Date Posted: April 22, 2004 at 8:16 AM
i use a warble tone generator made by Technics. Any good audio shop will have one... only problem is you'll need it for a while, and they are expensive.... if you run a shop or work in one, it is a good investment. Alot of them are built into frequency generators... which are also good investments for SQ sake.
-------------
|