Sony Xplod XM-DS1300P5

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=31013
Printed Date: July 06, 2025 at 4:28 PM

Topic: Sony Xplod XM-DS1300P5

Posted By: hot_shot_guy123
Subject: Sony Xplod XM-DS1300P5
Date Posted: April 25, 2004 at 7:27 PM

Hi, can this amp be bridged? I can't see anywhere in the manual that says so?

Replies:

Posted By: customsuburb
Date Posted: April 25, 2004 at 7:33 PM

This is a mono sub amp so it is basically bridged internally. It can handle a 2 ohm load so if you connected two 4 ohm sub to the plus and minus terminals you would get 400 watts RMS for your sub(s) (but sony overates their stuff).

Posted By: hot_shot_guy123
Date Posted: April 25, 2004 at 9:10 PM

I have 2 10" subs wired to 4 ohms running off of 1 positive and 1 negative. Should I be using both positive and negative terminals or just the 1 set?

Posted By: stevdart
Date Posted: April 25, 2004 at 9:27 PM

Just using one of each is correct. The other set is connected to the ones you are using, and are there to facilitate connecting two boxes.

-------------
Build the box so that it performs well in the worst case scenario and, in return, it will reward you at all times.

Posted By: hot_shot_guy123
Date Posted: April 26, 2004 at 11:32 AM

Thanks for the help guys, much appretiated!

Print Page | Close Window