04 mazda3 stereo diagram

Hi,does anyone know the wireing diagram for the mazda3 its a 2004.if theres anyone out there that knows the stereo wiring on this vehicle,please respond..

thanks for all your help!!!!!

-------------
Mr. Box

i'm doing an install in bout 30min from now i will let u know later what the wires r


-------------
"Keep your stick on the ice" Red Green

DIRECTWIRE™ WIRING INFORMATION - MAZDA / 3 / 2004 / Remote Start
[PRINT THIS PAGE]

12volts  red (30A), BLACK/ red (30A)  +  ignition harness Starter  gray/black  +  ignition harness Second Starter  N/A     Ignition  GREEN/ YELLOW  +  ignition harness Second Ignition  N/A     Third Ignition  N/A     Accessory  pink / YELLOW  +  ignition harness Second Accessory  yellow  +  ignition harness Keysense  RED / black  +  ignition harness Power Lock  GREEN/ red  -  driver kick, door harness Notes: Lock is negative trigger thru an 1,000 ohm resistor. Unlock is a straight negative trigger. MUST use relays. Power Unlock  same wire as power lock     Lock Motor  yellow/black  5wi  driver kick, door harness Unlock Motor  WHITE/ black  5wi  driver kick, door harness Parking Lights+  ORANGE / white (L), orange (R)  +  passenger kick, harness to rear Parking Lights-  BLACK/ white  -  headlight switch Hazards  BLACK/ orange  -  hazard switch Turn Signal(L)  blue  +  passenger kick, harness to rear Turn Signal(R)  blue/red  +  passenger kick, harness to rear Reverse Light  GREEN/ orange or GREEN/ black  +  passenger kick, harness to rear Door Trigger  see notes  -  passenger kick, harness to rear Notes: The LF door is BLACK / YELLOW, the RF door is BLACK/ blue, the LR door is BLACK/ orange, and the RR door is BLACK/ green. Use all four wires and diode isolate each. These wires are also found at the Passenger Junction Box behind the glove box. Dome Supervision  BLACK/ blue to BLACK/ red  -  passenger kick, harness to rear Trunk/Hatch Pin  BLACK/ red or BLACK/ blue  -  passenger kick or light in trunk Hood Pin  BLACK / YELLOW  -  hood pin switch Trunk/Hatch Release  N/A     Power Sliding Door  N/A     Factory Alarm Arm  BLACK/ blue  -  driver kick, door harness Factory Alarm Disarm  BLACK/ white  -  driver kick, door harness Disarm No Unlock       Tachometer  NOT GREEN/ stripe  ac  any ignition coil or fuel injector Wait to start  N/A     Brake Wire  RED / white  +  brake pedal switch Parking Brake  BLACK/ lt. green  -  parking brake switch Horn Trigger  black  -  steering column Memory Seat 1  N/A     Memory Seat 2  N/A     Memory Seat 3  N/A     Immobilizer Bypass Module: Required: Yes Type: Transponder Part #: 555U Notes: N/A

-------------
Do it right the first time

i have been installing for years and i'm certified but i'm not sure where to start to remove the the deck in the mazda3 ...i'm kinda of cuz the customer insists on being able to watch the install...which put s more pressure on me and honestly i don't want to make a mistake...I NEED TO KNOW HOW/WHERE TO START TO REMOVE THE STEREO AND ANY CODES THAT COULD HELP
THANK YOU FOR YOUR HELP

-------------
"Keep your stick on the ice" Red Green

The Mazda is just like all the Ford's. You need a key to remove the deck from the OEM location. These keys are required for removal of the deck. There should be 4 holes ( 2 on each side of the deck ) that you need to insert the keys into and pull all 4 keys to the side to release the locking tabs.

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA