amplifier
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=31607
Printed Date: June 06, 2024 at 5:59 PM
Topic: amplifier
Posted By: robblackman
Subject: amplifier
Date Posted: May 04, 2004 at 8:28 PM
Im am bridgeing a 4 channel amp to run two subwoofers but i dont know how to set lowpass / highpass ?
Replies:
Posted By: forbidden
Date Posted: May 04, 2004 at 8:59 PM
If you are bridging a 4 channel amp, the crossovers need to be set to lowpass for all channels. Make sure the crossover point is the same. Make 100% sure that each sub is in it's own separate enclosure. Without knowing the amp you have also make sure that you do not go below a 4 ohm rating on the bridged channels. MOre info is required, like make / model of the amp and subs and the type of voicecoils.
-------------
Top Secret, I can tell you but then my wife will kill me.
|