Print Page | Close Window

splicing rca connectors to din cable

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=31675
Printed Date: October 26, 2025 at 6:26 AM


Topic: splicing rca connectors to din cable

Posted By: Chappy
Subject: splicing rca connectors to din cable
Date Posted: May 06, 2004 at 12:34 AM

Just to make sure I am correct...

if this was the layout: pin 1 : +12 Amp Signal, pin 2: ground, pin 3: Left front, pin 4: right front, pin 5: left rear, and pin 6: right rear.. then to splice RCA connectors I would take the wire from pin 2 and run that to the negative of all 4 channels and pins 3 - 6 would be the positives right? and I would connect the pin 1 wire to the amp remote from the head unit. I am pretty sure this is right but I want to make sure.



-------------
Imagination and drive are the keys to greatness.
2000' Jeep Grand Cherokee Laredo



Replies:

Posted By: Ketel22
Date Posted: May 06, 2004 at 4:33 AM
yes that seems all in order.

-------------
Quad L Handyman services




Posted By: Chappy
Date Posted: May 06, 2004 at 9:11 PM
I did the splicing and installed a n alpine head unit today. Everything worked like a charm and it sounds awesome.

-------------
Imagination and drive are the keys to greatness.
2000' Jeep Grand Cherokee Laredo





Print Page | Close Window