'01 Stratus R/T w/Infiniti

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=3286
Printed Date: May 17, 2024 at 10:00 PM

Topic: '01 Stratus R/T w/Infiniti

Posted By: TimmyV
Subject: '01 Stratus R/T w/Infiniti
Date Posted: September 02, 2002 at 11:53 PM

I have a couple of questions in regards to this vehicle

1. Amplifier location

2. Color codes if you know them

3. Lastly, I only had a brief moment to look at the vehicle, but the rears had no visible wiring running to them, I am sure this is not a first for all, but it is for me

Thanks

-------------
Always use your meter:)

Replies:

Posted By: teampimp
Date Posted: September 03, 2002 at 2:52 AM

1. In the trunk or under your seat, but an amp needs atleast 2" inches of breathing space so they don't overheat.
2.You can order plugins which are color coded to match you new decks wires and it plugs into the factory harness.
checkout "bestkits.com" or "

3. If it turns out the the original wires are missing, you will have to run new wires under the interior or along the door jambs. It's little tricky but not too hard by yourself.

hope I could help.

-------------

Posted By: teampimp
Date Posted: September 03, 2002 at 2:54 AM

oh yeah another thing check out the "Metra kit" application guide on this site for harnesses.

-------------

Posted By: TimmyV
Date Posted: September 03, 2002 at 12:08 PM

sorry, i was not very clear in my request...i am looking for the factory infiniti amplifier and its wire codes in order to bypass or integrate

-------------
Always use your meter:)

Posted By: zorro33
Date Posted: December 06, 2002 at 6:19 PM

i trt to find the same for 97 chrysler town and country my new jensen has no sound

Posted By: Chris Luongo
Date Posted: December 08, 2002 at 4:08 PM

You don't need any special bypass pieces to get the factory Infinity---yes, Infiniy with a Y---to work properly.

Just be sure to attach the amp turn-on wire from the aftermarket radio to the power antenna wire in the harness, and the amp will turn on. If you're a professional, this is something you should do on every car anyway.

Posted By: Installer95
Date Posted: December 09, 2002 at 7:52 AM

No, you do need to bypass. Or Integrate the amp. Remember the Stratus R/T, and Sebring Coupe are Mitsubishi Eclipses in disguise. They use a Din cable from the radio to AMP.

https://www.eclipseforums.org

Check out this web site. This a forum for the 3rd Gen Eclipses which is the Baseline for the Stratus and the Sebring Coupe.

You essentially have two choices. You can run new wire to the Amp and rewire the amp plug or can use these.

https://www.audio-warehouse.com/detail.asp?mdl=HRC-MIT

https://www.sounddomain.com/sku/PERMITAH