2003 Dodge Stratus wiring diagam ,etc.
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=34691
Printed Date: May 12, 2025 at 1:48 AM
Topic: 2003 Dodge Stratus wiring diagam ,etc.
Posted By: kslamm
Subject: 2003 Dodge Stratus wiring diagam ,etc.
Date Posted: June 27, 2004 at 8:22 PM
Looking for a wiring diagram for a 2003 Dodge Stratus,any help would be gratly appreciated.Also anybody know the best possible way to hook up the remote turn on from my amp?Was not sure if the factory 4 disc changer that are in the Stratus' have a wire to splice into or if I need another alternative?Thanks.
Replies:
Posted By: jfk51502003
Date Posted: July 01, 2004 at 2:22 PM
DIRECTWIRE™ WIRING INFORMATION - DODGE / STRATUS SEDAN / 2003 / Remote Start[PRINT THIS PAGE]
| 12volts | pink/black & red | + | ignition harness | | Starter | yellow | + | ignition harness | | Second Starter | N/A | | | | Ignition | blue | + | ignition harness | | Second Ignition | GREEN/ red (20 awg) | + | ignition harness | | Third Ignition | | | | | Accessory | BLACK/ orange | + | ignition harness | | Second Accessory | BLACK/ white | + | ignition harness | | Keysense | | | | | Power Lock | WHITE/ green | + | conn. C4, pin 15 @ BCM | Notes: Lock requires a positive trigger thru a 1800 ohm resistor. Unlock requires a positive trigger thru a 750 ohm resistor. MUST use relays.
The BCM (Body Control Module) is attached to the fuse/relay box at the end of the dash on the driver side. Connector C4 is a 26 pin plug on the bottom edge of the BCM. | | Power Unlock | same wire as power lock | | | | Lock Motor | ORANGE / black | 5wi | conn. C4, pin 9 @ BCM | | Notes: The BCM (Body Control Module) is attached to the fuse/relay box at the end of the dash on the driver side. Connector C4 is a 26 pin plug on the bottom edge of the BCM. | | Unlock Motor | blue/white | 5wi | conn. C4, pin 13 @ BCM | | Notes: The BCM (Body Control Module) is attached to the fuse/relay box at the end of the dash on the driver side. Connector C4 is a 26 pin plug on the bottom edge of the BCM. | | Parking Lights+ | BLACK / YELLOW | + | headlight switch or DKP | | Parking Lights- | | | | | Hazards | | | | | Turn Signal(L) | | | | | Turn Signal(R) | | | | | Reverse Light | | | | | Door Trigger | | - | conn. C4 @ BCM | Notes: The driver door trigger is tan in pin 5, the front passenger door is tan/red in pin 6, the left rear door is tan/orange in pin 7, and the right rear door is tan / YELLOW in pin 8. Use all four wires and diode isolate each.
The BCM (Body Control Module) is attached to the fuse/relay box at the end of the dash on the driver side. Connector C4 is a 26 pin plug on the bottom edge of the BCM. | | Dome Supervision | use door trigger | | | | Trunk/Hatch Pin | tan/black | - | conn. C4, pin 18 @ BCM | | Notes: The BCM (Body Control Module) is attached to the fuse/relay box at the end of the dash on the driver side. Connector C4 is a 26 pin plug on the bottom edge of the BCM. | | Hood Pin | | | | | Trunk/Hatch Release | BLACK/ white | 5wi | conn. C4, pin 1 @ BCM | | Notes: The BCM (Body Control Module) is attached to the fuse/relay box at the end of the dash on the driver side. Connector C4 is a 26 pin plug on the bottom edge of the BCM. | | Power Sliding Door | N/A | | | | Factory Alarm Arm | lt. GREEN/ orange | + | conn. C4, pin 4 @ BCM | Notes: Arm requires a positive trigger thru a 1800 ohm resistor. Disarm requires a positive trigger thru a 750 ohm resistor. MUST use relays.
The BCM (Body Control Module) is attached to the fuse/relay box at the end of the dash on the driver side. Connector C4 is a 26 pin plug on the bottom edge of the BCM. | | Factory Alarm Disarm | same wire as alarm arm | | | | Disarm No Unlock | see factory alarm disarm | | | | Tachometer | NOT GREEN/ lt. green | ac | any ign. coil or fuel injector | | Wait to start | N/A | | | | Brake Wire | WHITE/ tan | + | brake pedal switch | | Parking Brake | | | | | Horn Trigger | BLACK/ red | - | steering column | | Memory Seat 1 | | | | | Memory Seat 2 | | | | | Memory Seat 3 | | | |
 | Immobilizer Bypass Module: | Required: Yes | Type: Sentry Key | Part #: 555C, 556U, or 555U | | Notes: Only vehicles with gray keys have the immobilizer. |
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. |
|
|