Print Page | Close Window

Components

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=35322
Printed Date: May 28, 2024 at 9:02 PM


Topic: Components

Posted By: jeansim
Subject: Components
Date Posted: July 09, 2004 at 10:43 PM

I've alrdy installed some system but never came across this one and it is in my own car.

All my wiring is done and now I jsut noticed that my wire connecting my crossovers to the speaker output of the amp have no + or - on them and I was wondering if it can hurt the xovers if I plug the negative in the positive and the positive in the negative. Thank for your advice. 



Replies:

Posted By: DYohn
Date Posted: July 09, 2004 at 10:47 PM
I'm not sure what you mean, but you want the + output of the amplifier connected to the + input on each crossover.  The wire doesn't need to be marked.  What matters is how it is connected.  One wire is probably striped and other one not striped (or one is copper and the other one silver) right?  Just make sure you've connected the same wire to the same terminal at each end.  Better yet, use an ohm meter and check for continuity...

-------------
Support the12volt.com



Posted By: jeansim
Date Posted: July 09, 2004 at 11:03 PM

Thank you that is exactly what I needed to know


Print Page | Close Window