Fosgate amp/subs

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=35977
Printed Date: July 12, 2025 at 10:38 AM

Topic: Fosgate amp/subs

Posted By: bcuz
Subject: Fosgate amp/subs
Date Posted: July 21, 2004 at 10:11 PM

I am going to drive two Rockford Fosgate P112S4 subs with a Rockford Fosgate P3001 amp. I am looking for suggestions on wiring the subs. I assume wiring the subs in series and running them at 2 ohms would be the best, am I correct?

Is there a way to wire them in series/parallel? Would this produce a four ohm load? If it is possible, which of the two scenarios would you recommend?

As always, thanks for any and all input. You guys are my hero.

-------------
bcuz

Replies:

Posted By: customsuburb
Date Posted: July 21, 2004 at 10:14 PM

You will want to wire them in parallel, (to get a 2 ohm load) and get the most power out of your amp (300 watts RMS which is the suggested RMS power for the P1s).

Print Page | Close Window