4 runner power wire

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=36828
Printed Date: May 14, 2025 at 8:29 AM

Topic: 4 runner power wire

Posted By: nuclearur
Subject: 4 runner power wire
Date Posted: August 05, 2004 at 12:29 PM

i'm redoing a system of one of my friends and i was wondering where the best place was in the firewall to run a 4ga wire..i doubt there is a hole big enough already to run it i was just curious to know where a good place would be. ohh ya the car is a 2003 4runner

Replies:

Posted By: kgerry
Date Posted: August 05, 2004 at 12:33 PM

look for an existing rubber boot or filler plug... you'll probably find one above and behind the gas pedal area... if not drill a hole and use a snap in grommet before you run your wire through it....

-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer

Owner/Installer
Classic Car Audio
since 1979

Posted By: 94legend
Date Posted: August 05, 2004 at 1:27 PM

kgerry is right
There should be a rubber boot or rubber filler plug, if its not located near the foot pedal there should be one in the center, you should be able to remove it with a screw driver,
is the battery located on the passenger or the driver side?

once the rubber is romoved there should be a hole, if its not big enough drill right into until its bigg enough and insert a grommet. Don't want your power wire to catch on fire!

Posted By: nuclearur
Date Posted: August 05, 2004 at 2:30 PM

thanks kgeryy and 94legend..the battery is located on the drivers side

Print Page | Close Window