Help on Kicker 1200.1 and 2 15"s

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=36853
Printed Date: May 11, 2025 at 9:17 PM

Topic: Help on Kicker 1200.1 and 2 15"s

Posted By: Xgen.m@$t3r
Subject: Help on Kicker 1200.1 and 2 15"s
Date Posted: August 05, 2004 at 8:12 PM

I'm getting 1 kicker kx1200.1 and wanted to see if someone could help me find a cheaper 1/0 guage installation than I have found..

I also would like to see if anyone has any idea how I can run my 1 15" Kicker CVR and a Kicker Comp until I get another 15" Kicker CVR. Thats 3 4ohm subs, I need them to come out to be 1ohm, but have no idea how I can do it without 2 15" Kicker CVR's.

Thx

Replies:

Posted By: Xgen.m@$t3r
Date Posted: August 05, 2004 at 8:19 PM

This is a few of my pictures of my current setup of subs, 2 15"s posted_image

Posted By: Xgen.m@$t3r
Date Posted: August 05, 2004 at 8:20 PM

This is a few of my pictures of my current setup of subs, 2 15"s posted_image

Posted By: Herald
Date Posted: August 05, 2004 at 8:22 PM

try www.knukonceptz.com good stuff better price

-------------
A person who carries or proclaims important news; a messenger.

Posted By: Xgen.m@$t3r
Date Posted: August 16, 2004 at 10:46 PM

Anyone have any idea how I can hook 3 4Ohm subs to this amp to get the most power?

Posted By: Charles_R_H
Date Posted: August 18, 2004 at 11:49 AM

if you run the compvr 15 and the comp 15 you can take it down to 1.33 ohms, i wouldn't suggest using the 2 different subs, if you run just the 2 comp vr's you can get down to one ohm, i would just run the two comp vr's at one ohm. or run four comp vrs, but you will run short on power

-------------
ELECTRONICS RUN OFF OF SMOKE, WHEN YOU LET THE SMOKE OUT THEY STOP WORKING

Posted By: Xgen.m@$t3r
Date Posted: August 18, 2004 at 5:20 PM

Well until I get another 15" CompVR I need to know how, and what will allow my amp to give the best power for a 15"Kicker CompVR and a 15"Kicker Comp... I know the Kicker KX1200.1 will do the following:

* 300 watts RMS x 1 at 4 ohms
* 600 watts RMS x 1 at 2 ohms
* 1200 watts RMS x 1 at 1 ohm
* Stable at 1 ohm

Both subs are 4 ohm... But each coil is 4Ohms.. And that means 3 coils should be hooked up... so If I go ahead and hook them up to where they pull 1.33 what will that be doing? What wattage? Would it be between 600 and 1200 RMS?