Ford Aerostar
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=37333
Printed Date: November 04, 2025 at 12:59 AM
Topic: Ford Aerostar
Posted By: Ravendarat
Subject: Ford Aerostar
Date Posted: August 13, 2004 at 3:20 PM
In the areostars with the controls behind the drivers side seat, what do you guys do to bypass the ones that dont use the standard ford plug. I always ran new wires to all the speakers in the vehicle but am wondering if there is a easier way.
-------------
double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer
Replies:
Posted By: extreme1
Date Posted: August 13, 2004 at 3:56 PM
You have to run new wires to the front speakers.
You have to run a wire from the drivers middle 6x9 up to the headphone control.
From there you can find the 2 rear and passenger middle speaker wires. Tie the driver rear and the new wire 6x9 together and wire them to the matching color wires corresponding to the colors at the radio harness. Do the same for the passenger wires.
-------------
Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta
Posted By: Ravendarat
Date Posted: August 13, 2004 at 4:22 PM
that will save me some time thanx. The one that came into today had the standard harness so it was fine but ill keep this on file for later.
-------------
double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer
Posted By: extreme1
Date Posted: August 13, 2004 at 6:30 PM
This is for all aerostars with the rear headphone controls. Wait til you get one with the factory EQ
-------------
Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta
|