Print Page | Close Window

93 sundance duster stereo

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=38121
Printed Date: July 06, 2025 at 8:19 AM


Topic: 93 sundance duster stereo

Posted By: liztic
Subject: 93 sundance duster stereo
Date Posted: August 26, 2004 at 8:31 AM

Hey, here's my problem. I've got an old sony cdx-2100 from a rummage sale. i don't have the wire codes knowing where to connect in the car. Naturally, when the last stereo was taken out they cut the wires. i have tested to see if it would power up on the car battery by twisting the red and orange cables and attaching the ground to the neg. the red power light didn't turn on, but i heard the cd deck read as though it was looking for a disc. question one, will the hu work if i wire properly, it did take power but the red power light never fired up.

question 2: i've done all the wiring searches here and found this link:

1992-93 Plymouth Sundance/Duster Stereo Information

for my g/f's cars wiring. but i don't have the proper wiring for the hu. i've got the most recent which is yellow for constance memory

red = ignition

black = ground

everything look right, or any suggestions?

thanks!!:errr:




Replies:

Posted By: the12volt
Date Posted: August 26, 2004 at 8:36 AM
Hi liztic ...head unit colors are the same as shown here: https://www.the12volt.com/request/request2.asp

-------------
posted_image the12volt • Support the12volt.com




Posted By: liztic
Date Posted: August 26, 2004 at 8:40 AM

thanks, i'll head out and give that a try. do  you think that the hu works b/c of the sound i got when wired? i don't want to go through this to find that it wont work. thanks again!!!





Posted By: liztic
Date Posted: August 26, 2004 at 10:22 AM

i made the retarded mistake of cutting my wiring harness off of my g/f's 93 sundance duster. can it be replaced as i've had some adapters given to me that would make installation that much easier!

thanks





Posted By: DYohn
Date Posted: August 26, 2004 at 10:31 AM
Yes.  You can solder the original connector back on or, if you don't have it, purchase one from a dealer or a junk yard.  Match up wire colors, solder and insulate.

-------------
Support the12volt.com




Posted By: Teken
Date Posted: August 26, 2004 at 10:49 AM
liztic wrote:

i made the retarded mistake



Its only a simple mistake. You are not a retard, unless you did not learn from this, and repeated it.

Then, the phrase would not be retard, it would be loser.

Regards

EVIL Teken . . .




Posted By: liztic
Date Posted: August 26, 2004 at 10:57 AM
thanks guys, good to see all is not lost...might just leave the soldering up the the pros and take from there!! thanks again





Print Page | Close Window