hello, i recently purchased a orion xtreme 800.4 amp. i was getting ready to hook it up, and a couple things cought my attention that wasnt on my last 4 channel amp. Where i plug in the remote wire, under the part that says Remote, it has 2 spots that says remote gain, lookin like u plug somethin into it like a rca type jack. and the remote wire i have isnt set up for something like that. is that even where i plug the wire in at? if so, which hole do i choose? Also, where it has the right and left speaker channels, where u plug the speaker wire in at, it of course has the 2 rights and 2 lefts. but what stumps me is along with those there is another jack where u can put a speaker wire in that isnt titled any thing, it doesnt say postive or negative either. I do not have a manual for this amp that is why im am here looking for help. i hope you guys can help.
-------------
would u like your chicken original or extra crispy?
On orion amps the remote turn on wire plugs into one of the clips that holds speaker wires. You have one plug with spots for 4 wires and one for spots with 5 wires. The one with 5 wires has the spot for the remote turn on wire off the deck. The RCA type connector is for a remote bass control for up front kinda like punch bass from rockford. I hope that helps.
-------------
double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer
yes thank you that does help. i did think the remote gain things were for a bass control thing, but since there are 2 plug holes, that threw me off, i also kinda thought the 5th jack was for a remote, but i didnt want to try it and risk damaging somethin because of a dumb mistake. i just wanted to make sure before i started tinkering around. thanks!!
-------------
would u like your chicken original or extra crispy?