getting rid of factory amplified speakers

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=41794
Printed Date: May 15, 2025 at 3:09 AM

Topic: getting rid of factory amplified speakers

Posted By: brashncurn
Subject: getting rid of factory amplified speakers
Date Posted: October 28, 2004 at 3:18 AM

I have an 89 Nissan Maxima with a bose system. I am trying to install a Panisonic head unit. I have wired the ground to ground, the power antena, the constant and the red accessory wire to the white wire that was in the car harnes. When I remove the faceplate the flashing lite blinks but I am not getting any power out of the system. Nothing comes on. My question is what am I missing?

Replies:

Posted By: thepencil
Date Posted: October 28, 2004 at 8:22 AM

You have to connect the blue/white wire from your Panasonic headunit to the factory harness to turn on the factory amp.

Here is the wiring diagram for your car.

Match the wire up against the headunit wire that you have, then it should work.

-------------
Be careful whose advice you buy, but be patient with those who supply it. posted_image

Posted By: jeffchilcott
Date Posted: October 28, 2004 at 5:03 PM

you also didnt list that you hooked up the switched ign source, this is a must

-------------
2009 0-1000 Trunk WR 154.0DB 2009 1001+ Trunk WR
2007 USACI World Champion
2007 World Record
2006 USACI Finals 2nd Place

Print Page | Close Window