dvc 12

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=42842
Printed Date: May 19, 2025 at 2:44 PM

Topic: dvc 12

Posted By: lawrenq
Subject: dvc 12
Date Posted: November 12, 2004 at 1:41 PM

i have two mb quart 4 ohm dvc 12s on a 700 watt 2 channel autotek amp what is the best way to wire them.

Replies:

Posted By: fuseblower
Date Posted: November 12, 2004 at 1:45 PM

I all depends on your amp and what you are trying to achieve. You can wire them down to two ohms per channel or you can bridge the two sub to make a 4ohm mono load.

But that's all dependant on your amp. I would wire my amp achieve the greatest SQ with the most power. Just see which wiring method has less distortion and go with it.

Posted By: lawrenq
Date Posted: November 12, 2004 at 1:48 PM

the amp that i have is the autotek sx-2300

Posted By: DYohn
Date Posted: November 12, 2004 at 1:56 PM

That's a stereo amp that is bridgable into a 4-ohm load. Connect your subs in series-parallel.

posted_image

-------------
Support the12volt.com

Posted By: lawrenq
Date Posted: November 12, 2004 at 5:43 PM

Thanks that works a whole let better than how it was.

Posted By: astro88
Date Posted: November 12, 2004 at 7:30 PM

How was it?,just curious

Print Page | Close Window