New setup need help?
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=45222
Printed Date: July 14, 2025 at 4:19 AM
Topic: New setup need help?
Posted By: eeh1025
Subject: New setup need help?
Date Posted: December 14, 2004 at 6:33 PM
Hey there im getting these subs
2 ROCKFORD FOSGATE STAGE 1 P112S4 12" subs
Which amp would be better for SQ
1 HIFONICS ZEUS ZX4000 2-CH AMPLIFIER
1 Rockford fosgate Punch P300 2-CH
Replies:
Posted By: Ravendarat
Date Posted: December 14, 2004 at 6:36 PM
I know nothing about that HIFONICS amp but if you decide to go rockford then get the 3001 not the 3002. You want a mono amp capable of running 2 ohms mono, that Rockford amp wont do that and that HIFONICS might not either so check it out first.
-------------
double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer
Posted By: eeh1025
Date Posted: December 14, 2004 at 6:41 PM
Yes your right i would just go with the 4omh p1 then.
Posted By: Ravendarat
Date Posted: December 14, 2004 at 6:46 PM
ok both the p1 and the p2 are both single voice coil 4 ohm drivers so if you want to run two of them then you must get an amp that is 2 ohm stable, at least if you want to run them effectivly.
-------------
double-secret reverse-osmosis speaker-cone-induced high-level interference distortion, Its a killer
Posted By: wheelerdr
Date Posted: December 16, 2004 at 8:59 AM
I would go to locustaudio.com and get a kenwood 811d this amp will do 4,2,or1ohm 230.00 great amp and will give you upgrade option later if you want better subs but for a little more i would get the 2 p3 dual 4 ohm in a ported box and wire them for 1ohm and push 1000 watts from this amp and you will give yourself a heart attach from the bass
-------------
|