Replacing Factory Sub
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=46047
Printed Date: May 17, 2025 at 11:43 PM
Topic: Replacing Factory Sub
Posted By: JVEE
Subject: Replacing Factory Sub
Date Posted: December 26, 2004 at 1:24 PM
The premium sub on a 2004 Subaru Forester XT is mounted in rear and is a 6x9. Not the best. I wanted to remove and substitute a factory plastic pocket that fits inside. Dimensions of the pocket are at least 4.5" deep, 5.5" wide, and 10" long. Is there a 6" or 8" driver that I can use in that space to take the place of the weak sub. I will feed it 120 watts bridged @ 4 ohms mono. I was thinking that I would seal pocket with MDF on top and fill with poly. Maybe place fiberglass or sound deadening on outside of pocket. Any ideas?
Replies:
Posted By: Bestbuy577
Date Posted: December 30, 2004 at 9:53 AM
Rockford Fosgate actually makes an 8inch sub driver that is reletively cheap...just check out their site https://www.rockfordfosgate.com
-------------
Best Buy Store#577 Oxford Valley, PA
|