I ordered one of this to run 2 Kicker Comp VR CVR10. Would that amp be enough??
The Amps Specs:
Class D design Frequency response 20-200 Hz 300w x 1 @ 4 ohms RMS 600w x 1 Peak 600w x 1 @ 2 ohms RMS 1200Wx 1 Peak Signal to Noise Ratio: 95dB Input Voltage: 13.8V MOSFET power supply Variable low-pass crossover 50-200 Hz at 12 dB per octave Switchable subsonic filter 25 Hz, 12 dB/octave Preamp- and speaker-level inputs Preamp outputs KickBass boost (0-18 dB of boost at 40 Hz) Remote bass level control with 20-foot cable Amp-Strapping circuit allows two identical KX Series mono amps to be joined to produce double power Requires 4-gauge power and ground leads wiring and hardware not included with amplifier Fan-cooled - Impedance- 4ohms
- Cone Material Poly mineral
- Surround Material - Santo prene rubber
- Sealed Box Volume - 0.8 - 3
- Ported Box Volume-1.25 - 1.75
- Dual Voice Coil - Yes (2 or 4)
- Sensitivity - 85.6dB
- FrequencyResponse - 25 - 0.5k Hz
- RMS Power Range - 50- 300
- Peak Power Handling - 600
- Top Mount Depth - 5 1/16
- Bottom Mount Depth - 5 13/16
- Cutout Diameter or Length - 9 5/16
- Vas - 40.4
- Fs -33.1
- Qts - 0.564
- Xmax - 11.5
I had that amp running 2 rockford he2s...blew one of them....
and made my chest hurt...
It would be enough...
but those comps are probably 400watts rms like my rockfords and my kx puts out 730 peak...its underrated...
those need close to 400 a piece...
Good luck
-------------
What makes my car Bang:
Kicker KX 600.1 Mono amp (2004)
Kicker Solobaric L7 10 (2004)
Long Ported Box Single
Kicker 200.4 4 Channel(2004)
Kicker DX 60 6 1/2
Rockford Fosgate FRC3369 6x9