connecting rca converter to factory head

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=46381
Printed Date: July 13, 2025 at 1:56 PM

Topic: connecting rca converter to factory head

Posted By: 97bmwm3
Subject: connecting rca converter to factory head
Date Posted: December 30, 2004 at 12:36 PM

i dont know which cables from the input leads to which cables to the head unit leads the converter leads are left positive white--------- left negative WHITE/ black-------right positive gray--------right negative gray/black

and i was wondering if u can tell me how to install the remote lead to a switch and to the ignition source and do i need a fuse for this

Replies:

Posted By: Francious70
Date Posted: December 30, 2004 at 12:41 PM

Check the info database and see if your car's listed.

https://www.the12volt.com/installbay/forum_topics.asp?fid=7

Then connect the LOC leads to the appropriat rear speaker wires and your done.

As for the remote, run a wire from the fusebox to the amp, connect the wire to whatever fuse is used for the radio.

Paul

Posted By: 97bmwm3
Date Posted: December 30, 2004 at 1:07 PM

Francious70 wrote:

Check the info database and see if your car's listed.

https://www.the12volt.com/installbay/forum_topics.asp?fid=7

Then connect the LOC leads to the appropriat rear speaker wires and your done.

As for the remote, run a wire from the fusebox to the amp, connect the wire to whatever fuse is used for the radio.

Paul

Posted By: dedlyjedly
Date Posted: December 30, 2004 at 2:46 PM

FRANCIOUS HAS YOU COVERED-

MAKE SURE YOU CONNECT TO THE "HOT SIDE" 9SHOWS POWER WITH OR WITHOUR THE FUSE IN PLACE) OF THE FUSE & REMEMBER TO USE A FUSE INLINE ON ANY POWER WIRES YOU RUN!

-------------
MECP certified, 5yrs experience, you probably otta listen bitch!!

Print Page | Close Window